1
Third party software and hardware support forums. / Re: StepmasterNC 4 axis controller, Any info?
« on: July 26, 2009, 01:24:25 PM »
Ok Bob, I just assumed you could get it from here.
I am
paul@g4osj.freeserve.co.uk
Initially I want to just do some engraving and I also have no pressing schedule. However, I have been hanging about with one thing and another for too long. Time to get started.
Paul.
I am
paul@g4osj.freeserve.co.uk
Initially I want to just do some engraving and I also have no pressing schedule. However, I have been hanging about with one thing and another for too long. Time to get started.
Paul.