Hello Guest it is October 07, 2022, 07:01:46 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ROCKO86

Pages: 1
1
General Mach Discussion / Re: Using Mach 3 Pulsing Engine
« on: October 26, 2010, 09:52:13 AM »
If I use io.dll or inpout32.dll the signal is bad, there are "stucks" in it. I mean, let's say the frequency is 1 unit long. But when the signal stucks (in +1 or 0), the length is 3-4 unit (or more). In the stucks, there's no pulse, so the stepper motor stops a little bit, and it doesn't work properly, only with the Mach3 Pulsing Engine.

2
General Mach Discussion / Re: Using Mach 3 Pulsing Engine
« on: October 26, 2010, 05:54:45 AM »
Guys, no one? Nothing? :(
Any idea?

3
General Mach Discussion / Using Mach 3 Pulsing Engine
« on: October 24, 2010, 06:23:27 AM »
//I have already posted it another category - maybe I did it wrong, sorry.

Hello!

Is there a way that I can use Mach3 Pulsing Engine?
I mean, as you may know, there are io.dll or inpout32.dll. With these I can control the parallel port, but they are not precise at all.

I'm using WinXP SP3 and interested in any solution (especially Delphi, but I would be very thankful for any visual basic, visual c++, visual c# ideas).

Thank you very much!

Zoltan Szabo

4
VB and the development of wizards / Using of Mach 3 Pulsing Engine
« on: October 22, 2010, 08:43:07 AM »
Hello!

Is there a way that I can use Mach3 Pulsing Engine?
I mean, as you may know, there are io.dll or inpout32.dll. With these I can control the parallel port, but they are not precise at all.

I'm using WinXP SP3 and interested in any solution (especially Delphi, but I would be very thankful for any visual basic, visual c++, visual c# ideas).

Thank you very much!

Zoltan Szabo

5
LazyCam (Beta) / Re: Missing chain in G-code
« on: July 15, 2009, 11:15:36 AM »
Hey Guys!
It works fine! Thank you very-very much!

Of course, the demo version only handle the first 500 lines, but right now it is enough for testing. If everything works fine, I promise that I will buy a full license. ;)

Thank you again, keep up the good work!

6
LazyCam (Beta) / Re: Missing chain in G-code
« on: July 14, 2009, 05:54:22 AM »
Hi Chip!

I have a similar problem as ojibberish. I wrote a simple text ("ShopZ.hu") in CorelDraw11. I export the file as .dxf. I import the file in LazyCam. The LazyCam recognize it, I see the text in the program. But when I want to make the G-Code the LazyCam doesn't make the whole G-Code of the "Shopz.hu".

I am using Windows XP Professional, SP3; CorelDraw11.633; LazyCam 3.00.2; Mach3 Demo Version R3.042.020.

I attach the dxf file and the wrong tap file; please, have a look at it.

What could be the solution? Should I reinstall the LazyCam and the Mac3?

Thank You:
Zoltan Szabo.

Pages: 1