Messages

1

General Mach Discussion / Re: Problems threading on the lathe

« on: July 06, 2009, 07:44:56 AM »

Hi . Hood

I think my spindle feedback may be faulty . am checking.
I did not find G76 in the Mach3 G code list so assumed it was not supported.

   mechcjose.

2

General Mach Discussion / Re: Problems threading on the lathe

« on: July 05, 2009, 04:15:33 AM »

I have just started to use Mach 3 lathe . When I try the threading program it runs but stops at at a line with G76 X0.4 Z-2 Q2 P0.05 J0.006 L0 H0.005 I29 C0.025 B0.0001 T0.  I understand that this is a fine boring canned cycle not supported by Mach3 .has anyone else had this problem? and what is the fi?.
  mehcjose.