1
General Mach Discussion / Re: Hobby cnc board work with 127 oz steppers and not with 200 oz steppers
« on: January 06, 2007, 04:09:48 AM »
yes it is set to
X axis Y Axis Z axis
steps per mm - 2130 2130 2130
velocity - 300 300 200
acceleration - 100 100 100
step pulse - 5 5 5
dir pulse - 5 5 5
if not correct please tel me wat it should be
other settings:
Driver bord is set to 1/16 steps
and as I said the smaller 127 oz 1A steppers work great
Graham
Will you please send me your settings for mach3 so that i can just get jhe motors running and I can then later set it for my router
Thanx
Johann Badenhorst
X axis Y Axis Z axis
steps per mm - 2130 2130 2130
velocity - 300 300 200
acceleration - 100 100 100
step pulse - 5 5 5
dir pulse - 5 5 5
if not correct please tel me wat it should be
other settings:
Driver bord is set to 1/16 steps
and as I said the smaller 127 oz 1A steppers work great
Graham
Will you please send me your settings for mach3 so that i can just get jhe motors running and I can then later set it for my router
Thanx
Johann Badenhorst