Messages

1

General Mach Discussion / Re: Help: My Step pin stay high all the time.

« on: July 04, 2009, 02:34:46 AM »

:-(

No one have any other idea why my step pin stay high all the time after the first step???

Amit Prigozin

2

General Mach Discussion / Re: Help: My Step pin stay high all the time.

« on: July 03, 2009, 06:45:54 PM »

I cheack the volatge with FLUKE, and the pin stay high all the time, it is not the controller.
What is DROs? this is the number the represents the axe postion? becuse if yes-so they stop when I realse the key, if not-so I dont know what is DROs...

Thenks,
Amit Prigzoin

3

General Mach Discussion / Re: Help: My Step pin stay high all the time.

« on: July 03, 2009, 06:28:08 PM »

I connect the wire to my controller which connected to 4 leds, each led repesent a coil of the step motor.

the leds keep changing all the time without stopping, they move in the right order (CW/CCW) but they dont stop when the command stop

4

General Mach Discussion / Re: Help: My Step pin stay high all the time.

« on: July 03, 2009, 06:16:32 PM »

Nop...

Not help...

5

General Mach Discussion / Re: Help: My Step pin stay high all the time.

« on: July 03, 2009, 03:38:20 PM »

Thenks,

Here is my xml file

http://www.megaupload.com/?d=7VEZ1TT7

In this file I config only my X axe.

6

General Mach Discussion / Help: My Step pin stay high all the time.

« on: July 03, 2009, 12:13:00 PM »

Hello,

My name is Amit, and I new to this softwere.
I build a simple CNC mechine. until now I build the X and Y axe, and i keep upgrade it all the time.
Until now I use turbocnc for windows, but this is very old and not easy to use softwere, so I decide to move to Mach3.

I start to config the softwere, but I have problem: my Step pin stay all the time high (or low if I config "Step low active")
For exmpale when I open the softwere, and enter JOG mode, in the begin the step pin is low, but when I did even one step, it stay high all the time.
Why this is happen? How I fix it?

Thenks a lot,
Amit Prigozin