Hello Guest it is May 31, 2023, 11:46:40 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jaime18253

Pages: 1
1
Hi
 my name is jaime vargas, I live in bogota colombia , At this moment I am installing a machine with sofware mach 3 the this totally new machine but in the installation of the machine I have had enough problems with the sofware, comment on the machine to them it(he,she) moves his(her,your) three axes(axles) normally, but the disadvantages that I have are the following ones, the machine does not recognize the home and x it(he,she) recognizes it and z it(he,she) does not also recognize it besides it if I locate the machine in a point anyone and give him setup or point zero and despues displace the machine does not return to the same point .. I was fitting the blackslash but it(he,she) was not possible until you or someone me envie the normal configuration ... as that I do not have a north.... Besides it when I am going to generate the codigo g in lazy cam ... in occasions it(he,she) generates it and in occasions or better the great majority does not do it ..... not to which this owes ..... cant to guide ...., another disadvantage that I have is that when it(he,she) loads the figure in the visualizador of the mach it(he) remains lost ... since I do to centre it ... and to prevent the screw from moving up to where the drawing stays ... I hope that they could help me, 
Grasias jaime

Pages: 1