Hello Guest it is March 28, 2024, 10:53:38 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sd_cnc

Pages: 1
1
JetCam screen designer / Re: List of Jetcam requests :)
« on: September 29, 2007, 06:47:19 PM »
Hi Stan,

What is your offline email address? I have a question for you.
Thanks,
Li (xinbingli@yahoo.com)

2
Works in progress / Re: Graphite Beta
« on: March 05, 2007, 03:45:58 AM »
Zealous,

I have to disable the Mach3 driver in device manager to make Mach3 work with flash screen at normal speed and to enjoy your wonderful flesh screen.
Thank you, Ynneb and Art for your work and your time to bring up these new face of screens. (The Area 51 is a good one ,too.)

I attached a PM from my Intel 4 2.4G 512MB PC here, it is in normal boot-up, with Mach3 driver enabled and Graphite Beta loaded.
I really want to know what causes my PC not run well when using Mach3 driver, printer port and flash screen all together.

Thanks, Li

3
Works in progress / Re: Graphite Beta
« on: March 04, 2007, 02:36:47 PM »
Zealous,

No luck with Mach3 v053 and flashplayer 8 plugin. The problem of "slow-motion" is still there.
When running drivertest.exe, I can see it stops updating the readings once any flash application starts running.   

Should I upgrade my RAM to 1G range?

Thanks, Li

4
Works in progress / Re: Graphite Beta
« on: March 03, 2007, 06:23:31 PM »
Zealous,

After selecting flash screen first and  restarting Mach3, I still have the same problem of "slow-motion" screen when using flash screen set.
I found Mach3 does not work well in my PC whenever there is a flash application in using, such as opening a website with a flash embedded. I have to close all flash applications and run drivetest.exe to get the PC back to normal.

I have tried my two PCs, and both have the same problem.
PC config : AMD Duron, 1.6G 625M RAM  and Intel P4 2.4G 512M RAM, both on XP and Flash player 9

Thanks, Li

5
Works in progress / Re: Graphite Beta
« on: March 02, 2007, 11:57:12 AM »
Zealous,

My Mach got slowed down when using flash screen, the E-stop LED was flashing every 2 to 3 seconds, kind of in slow motion. I am using latest version of Mach and Flash.
I see you don't have this problem in your demo. Is this related to CPU speed, RAM or other configuration?  Any tricks to run flash screen?

Thanks, Li

Pages: 1