Hello Guest it is November 13, 2019, 05:04:58 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - plastec01

Pages: 1
1
General Mach Discussion / steppers loose steps
« on: July 07, 2009, 05:10:32 PM »
I have a taig with steppers and a geco board but my x axis looses steps sometimes not responding at all. I switched axis plugs and the problem moves to the Y axis
sometimes it is better with faster feeds (above 1.0)

the only thing I see is it has a message bwm bumped to min setting anyone know what this means?

thanks

2
Newfangled Solutions Mach3 Wizards / Re: x axis stops
« on: July 01, 2009, 10:01:26 PM »
by the way I was using newfangled solutions wizard package

3
Newfangled Solutions Mach3 Wizards / Re: x axis stops
« on: July 01, 2009, 10:00:09 PM »
Hey rich new computer mach3 works fine as far as I can tell have done 10 hrs/day on it last 3 days no crashes that said seems strange this problem is only happening with this wizard as far as I can tell,  but why is beyond me.  I thought it was heat build-up in motor maybe but put on a new motor and it happens every time I use this wizard I will program through alibre cam tomorrow to see if it is ok. unfortunately there were no other wizards to do a rectangulat groove.

John
Plastec

4
Newfangled Solutions Mach3 Wizards / x axis stops
« on: July 01, 2009, 07:18:53 PM »
I am trying to cut a rectangle and the x axis stops since I have steppers the dro continues and the program thinks it is running  if I switch the x and y motors the y stops so it isn't  a motor, ending the program motors run fine also seems to work in non newfangled wizards any chance this is being caused by the wizard?

thanks

5
General Mach Discussion / Re: help can't load g-code
« on: June 25, 2009, 04:11:22 PM »
I don't have any plugins or pump  I got it to load a file in the middle of cutting error message came up and the program closed

???

I am going to put a different computer on the machine

? stumped

6
General Mach Discussion / Re: help can't load g-code
« on: June 24, 2009, 03:48:21 PM »
Thats  thanks  it even came up just now when I exited the program

7
General Mach Discussion / Re: help can't load g-code
« on: June 24, 2009, 03:47:15 PM »
tha

8
General Mach Discussion / Re: help can't load g-code
« on: June 24, 2009, 03:40:03 PM »
I reinstalled it no help same error I can't even get to pick a file to load. this sucks

9
General Mach Discussion / help can't load g-code
« on: June 24, 2009, 02:40:54 PM »
Help I can't load g-code get "art code 9991" error as soon as I go to file load any one know how to fix sometimes does it when I load lazy cam   Help need to fix asap

thanks

Pages: 1