1
General Mach Discussion / Re: Strange arcs in imported file from D2NC into Mach3, please help
« on: June 18, 2009, 09:09:42 AM »
Here's the screenshot and gcode from D2NC.
Is it possible that I hit a key and changed some setting on accident? I remember wiping off the keyboard when some oil spilled on it during machining, and the arcs were not there for the first few test runs of that part.
Thanks again for your help.
Alex
Is it possible that I hit a key and changed some setting on accident? I remember wiping off the keyboard when some oil spilled on it during machining, and the arcs were not there for the first few test runs of that part.
Thanks again for your help.
Alex