Hello Guest it is October 28, 2021, 12:42:52 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - (nater)

Pages: 1
1
General Mach Discussion / Re: Tool Height Touch Probe
« on: June 19, 2009, 07:51:34 AM »
you copy and past this into your m6start. file and it will perform this through out your program perfectly the others dont seem to work so well

2
General Mach Discussion / Re: Tool Height Touch Probe
« on: June 19, 2009, 07:49:56 AM »
this works best wile you are in program

code "g90"

ChX = GetUserDRO( 1200 )
ChY = GetUserDRO( 1201 )
ChZ = GetUserDRO( 1202 )

Code "G53 G00 Z-0.1" 'Move the tool all the way up
Code "G53 G00 X" & ChX & "Y" & ChY 'Move to the probe position
While IsMoving()
Wend

Code "G31 Z-7 F10" 'Z move down untill hit
While IsMoving()
Wend
ZposOld = GetVar(2002) 'Get the Position that the Porbe hit at
Code "G53 G00 Z-0.1"'Z move all way up
While IsMoving()
Wend

MsgBox ("Insert the new tool")
MsgBox ("Ok to finish tool change")

Code "G53 G00 Z-0.1" 'Move the tool all the way up
Code "G53 G00 X" & ChX & "Y" & ChY 'Move to the probe position
While IsMoving()
Wend

Code "G31 Z-7 F10" 'Z move down untill hit
While IsMoving()
Wend
ZposNew = GetVar(2002) 'Get the Position that the Porbe hit at
Offs = ZposOld - ZposNew
Call setdro (2,&Offs)   'Set the value of the DRO to the value that is in "Offs"
Code "G53 G00 Z-0.1"   'or hoever high you want to go to get up safely off the probe
MsgBox ("Ok to return to program")

Code "G00 x0 y0"

Pages: 1