Messages

1

General Mach Discussion / Re: Line Limit with License

« on: June 03, 2009, 11:55:51 AM »

Good suggestions, thanks!

2

General Mach Discussion / Re: Line Limit with License

« on: June 02, 2009, 11:52:37 PM »

Doh!  Thanks!

3

General Mach Discussion / Line Limit with License

« on: June 02, 2009, 09:25:06 PM »

I have a piece of gcode which was 277 lines long and I added a subroutine to it and Mach3 will only show 276 lines leaving off the final line, M99 (which, of course, is there when I view the code to edit).  I used the same subroutine in a similar piece of code, the piece is just smaller with a few less cuts (less lines of code) and it worked fine.  I decided the issue was that I still had just the demo version so I purchased a license, successfully installed it and there's no difference.  Is there something in the configuration that would limit me in this way?  Has anyone else experienced a limit of lines of code even with a license?

Thanks.