Hello Guest it is July 22, 2019, 06:27:43 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Mike944

Pages: 1
Yeah, i guess you're right.   The backlash should not change constantly.   I guess i was just looking for a way to duplicate the original controller's behavior.



I have a machine i'm retrofitting (Dyna 2400) which has limit/home switches specifically designed to have no hysteresis, for use in an automatic backlash compensation routine that the original controller had.

Can Mach automatically set backlash numbers during the homing routine using the limit/home switches?  if so, how?


Pages: 1