Messages

1

General Mach Discussion / Re: axis direction

« on: May 11, 2009, 10:47:46 PM »

simply invert the axis under "motor output" settings... or you can change your hotkey (Config>System HotKeys) but the 2nd step will not change how your cnc will run under the same g code.

2

General Mach Discussion / Mach 3 won't run under certain Laptop

« on: May 11, 2009, 10:41:58 PM »

I installed Mach 3 on my IBM X31 land an older HP aptop and it works perfectly but when I install it on my dell and T41 laptop it doesn't work.  I cannot use hot key to move the axis.  I also try to use the built-in wizard feature to generate some gcode and run it.  Still it won't run...(the X Y Z axis numbers were not changing)  Yes I have cleared the reset and I just don't know what's wrong with it