1
Mach3 under Vista / Re: Getting up and running in Vista
« on: October 31, 2012, 12:46:14 PM »
I am moving to a newer computer running windows 7 home premium. I installed the same version of mach 3 I was running on my old computer R3.043.022. I ran the driver test and it completed successfully. I am running at 35000K kernel speed.
I am moving from an old celeron computer (xp pro) to a core 2 duo 2Ghz computer. Everything is working but I am having an issue.
I have jog speed set to 150in/min. On the old computer I can hold down the jog key and it will read 150in/min on the screen with slight variation of 0.05 ipm. On the new computer it will vary from 146 to 150ipm. What made me notice it was the sound on the steppers. I could hear the variation. Any ideas what would cause this?
Mach 3 is using the same config file (xml) on each computer.
video of new computer with variation
http://www.youtube.com/watch?v=tw9XA-IwPTk
old computer without variation
http://www.youtube.com/watch?v=vQfq1hnx7c4
I am moving from an old celeron computer (xp pro) to a core 2 duo 2Ghz computer. Everything is working but I am having an issue.
I have jog speed set to 150in/min. On the old computer I can hold down the jog key and it will read 150in/min on the screen with slight variation of 0.05 ipm. On the new computer it will vary from 146 to 150ipm. What made me notice it was the sound on the steppers. I could hear the variation. Any ideas what would cause this?
Mach 3 is using the same config file (xml) on each computer.
video of new computer with variation
http://www.youtube.com/watch?v=tw9XA-IwPTk
old computer without variation
http://www.youtube.com/watch?v=vQfq1hnx7c4