1
General Mach Discussion / Re: Controller for New Hermes Vanguard 3000 Engraver
« on: January 03, 2010, 01:31:11 PM »
Hey XrayMan,
I have a Vanguard 3400. Tossed the EP, bought a iso board and added Mach3 with an XP comp.
Everything seems fine exxcept I missing steps in all 3 axis over longish runs. Any thoughts? Could The steppers be bad? Or maybe the set-up is not quite right. Any thoughts would be appreciated!
Thanks,
SpicySkier.
I have a Vanguard 3400. Tossed the EP, bought a iso board and added Mach3 with an XP comp.
Everything seems fine exxcept I missing steps in all 3 axis over longish runs. Any thoughts? Could The steppers be bad? Or maybe the set-up is not quite right. Any thoughts would be appreciated!
Thanks,
SpicySkier.