1
General Mach Discussion / Re: Bridgeport V2XT, SX-16, conversion to Mach3
« on: April 11, 2009, 11:06:53 PM »
Thanks Hood for the reply and the info
Found a working V2XT DX32 with a BMDC this weekend 04/11/09 so I'll hold off on the conversion to Mach3 for now.
Did check out the Galil boards and Wow the mill I just purchased didn't cost that much but if your desperate to get your mill up and running it's a bargin.
Randy
Found a working V2XT DX32 with a BMDC this weekend 04/11/09 so I'll hold off on the conversion to Mach3 for now.
Did check out the Galil boards and Wow the mill I just purchased didn't cost that much but if your desperate to get your mill up and running it's a bargin.
Randy