Messages

1

Galil / Re: galil thc

« on: April 18, 2010, 05:30:32 PM »

Is there any news on this thc in galil as I have begun working on the plasma again and would still like to use thc in the galil

2

Galil / Re: galil thc

« on: July 01, 2009, 08:42:54 PM »

If you look at the experimental thc plugin written by Brian Barker it has everything needed. But it has to be done in the galil for the fast update. It should only work when the torch is in motion.

3

Galil / galil thc

« on: June 29, 2009, 10:51:29 PM »

Has anybody tried to write code for the galil controller to use the analog input for torch height control without going through mach3. It appears that mach has to slow an update rate 10hz or is there away to get mach to look at this faster.

4

General Mach Discussion / Re: Mach 3 and Galil Motion Control boards

« on: June 03, 2009, 10:06:34 PM »

hello all,
I am going to use the galil plugin and a dmc-2180 controller on a plasma cutter and would like to know if you can use a thc with this plugin.

5

General Mach Discussion / Re: Mach and External Motion control devices

« on: March 17, 2009, 09:11:25 PM »

has anybody done any work with the delta tua umac controller using Ethernet or usb. I would like to make a plasma machine and these controllers are common at my work.