1
General Mach Discussion / Re: Motor tuning calculations
« on: April 25, 2009, 08:26:44 PM »
I would agree that noise could be in issue if it were intermitent or unpredictable, that is not the case though. Being a programmer with electronics and working in the electrical field I am pretty good at trouble shooting problems. Sometimes though asking the correct questions is a problem. In this case not alot to go on as most use the most common drives and control devices and do not have these experiences. These devices however are overpriced and place more on a name. The electronic part are not more then maybe 25.00 but they seem to charge alot. Mach3 on the other hand pretty good bang for the buck but I did need to make sure it was not causing an issue with my setup and if it is how to correct it ... time will tell soon enough.