Hello Guest it is November 12, 2019, 10:37:49 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bjones

Pages: 1
1
General Mach Discussion / Re: help with tool length offsets
« on: March 26, 2009, 04:24:02 PM »
Thanks,
so when I use g31 with my auto z probe 1st, that registers as tool 0?
If i try using g31 for say setting tool 6 later, that z height will then become the datum?
That might be where problems are arising.
Bill

2
General Mach Discussion / help with tool length offsets
« on: March 26, 2009, 01:45:31 PM »
Hey fellas,
I'm setting up a tool changer on my mill and have a question about TLO's.
I know mach needs a datum tool set 1st to reference the other tools but
have read posts saying the datum tool is tool 0 while others say tool 1.
If it is tool 0, how can you enter the Z height in the tool table?
I'm running ver 3.039.
Thanks Bill

Pages: 1