Hello Guest it is March 29, 2024, 06:55:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jordan21

Pages: 1 2 »
1
Does anyone have any ideas?

2
General Mach Discussion / HELP PLEASE! homing limit troubleshooting
« on: May 12, 2017, 09:21:56 PM »
I have an ez-router cnc.  I have been troubleshooting the last week to no avail.  When I reference all home the z goes up and touches the limit switch but it won't back off of it.  It just keeps crashing into it.  So I replaced the limit switch and it does the same thing.  I've replaced a ribbon cable, parallel cable, and limit switch.  Nothing worked.  I went into the button script editor and deleted the dobutton 24 to stop the z from homing.  I then try to reference all home again with just the y and x axis.  The y axis comes back and touches the limit switch and does the exact same thing.  I am at a loss on want to look for.  I am a week behind on schedule and am no closer in figuring this thing out.  Any and all guidance would be appreciated.  Thanks

3
General Mach Discussion / Re: tool dro
« on: March 25, 2010, 09:23:07 AM »
Here it is.

4
General Mach Discussion / Re: tool dro
« on: March 24, 2010, 09:30:18 PM »
I checked, that is set correctly.

5
General Mach Discussion / tool dro
« on: March 24, 2010, 09:04:40 PM »
I have been using a custom screen set for my router.  I'm having trouble with it changing the tool dro when it calls for a tool change in the gcode. I have a custom macro that depends on this to change.  The standard 1024 screen set changes the tool dro  with no problem.  I really want to use the custom screen set, but I don't know what to look for or what could be causing this.  Any ideas?

6
General Mach Discussion / Re: SPINDLE WON'T SHUT DOWN
« on: May 07, 2009, 10:14:13 PM »
i've got a bob campbell b/o board with a seperate sound logic spindle speed board.

7
General Mach Discussion / Re: SPINDLE WON'T SHUT DOWN
« on: May 07, 2009, 09:01:14 PM »
no, my the minimum is already at 0.

8
General Mach Discussion / SPINDLE WON'T SHUT DOWN
« on: May 07, 2009, 07:48:20 PM »
Any ideas why my spindle won't completely stop.  When I get finished running a program the spindle winds down from 18000 to around 3000 rpm but won't completely turnoff.  On the mach screen it shows it as off but on my vfd it hovers around 3000 rpm.  The only way to get it stopped is to type 0 in the mach screen and hit the spindle button.  Does anyone have any ideas on what might be happening?

9
General Mach Discussion / Re: I need help setting up my air drill
« on: March 29, 2009, 08:15:42 PM »
Can you explain a little further.  I am pretty new at all of this.  Could someone possibly show me some sample code on what you are talking about?

10
General Mach Discussion / Re: Problems setting up my air drill
« on: March 27, 2009, 05:55:58 PM »
Just to be a little more clear, I already have the drill installed and running.  The question I have, is how and where to assign an offset to the drill, so when I'm running a drilling operation mach knows where the bit is in the x and y.

Pages: 1 2 »