Guest
Show Posts
1
General Mach Discussion / Early Version of MAXNC Closed Loop System
« on: March 24, 2009, 03:41:07 PM »
This is my first post on this forum, so hope this is the appropriate location. I have an early (1999) version of the close loop system which I am trying to get operating under Mach III. This version required two bidirectiional printer ports and ran under DOS. Can anyone provide assistance? I can get some movement on some of the axes using the MAXNC-10 Wave Drive, but not with the Max CL Mode enabled boxes checked.
The users manual that came with the system is titled "MAXNC SRV-S. I am working with Chris at MAXNC, but he is not familiar with this version.
According to the manual, this is the structure:
Port Address 1 -- X&Y codes -- 278 Hex
Port Address 2 -- X encoder input -- 27A Hex
Port Address 3 -- Yencoder input -- 279 Hex
Port Address 4 -- Z&A codes -- 3BC Hex
Port Address 5 -- Z encoder input -- 3BE Hex
Port Address 6-- A encoder input -- 3BD Hex
Thanks,
Jerry
The users manual that came with the system is titled "MAXNC SRV-S. I am working with Chris at MAXNC, but he is not familiar with this version.
According to the manual, this is the structure:
Port Address 1 -- X&Y codes -- 278 Hex
Port Address 2 -- X encoder input -- 27A Hex
Port Address 3 -- Yencoder input -- 279 Hex
Port Address 4 -- Z&A codes -- 3BC Hex
Port Address 5 -- Z encoder input -- 3BE Hex
Port Address 6-- A encoder input -- 3BD Hex
Thanks,
Jerry