Hello Guest it is March 28, 2024, 09:21:32 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ultimatehac

Pages: 1
1
General Mach Discussion / configure drive for motors
« on: March 22, 2009, 12:41:48 PM »
Heloo everybody..I am new here and i would like to say that this software(i am talking about MACH3),looks like it is very good.I wanna build a motor driver with a PIC controller and i have a question that i would like to be answered. As i undeerstand,the output signal that comes from the LPT port for controling the motor comes from one pin(configured output pin from the LPT port) and it is an impulse signal.From that signal i should control a stepper motor,lets say it is bipolar,who has 4 wires coming out from him.So i was wondering if i get it right,does every impuls coming out from the configured output pin from the LPT for controling the motor,should go on  one the next coil from the motor,sort of like impuls multiplexing for every coil??? My english is not so good good,so i am sorry if i made any mistake but i nope you will know what i am trying to ask.

Pages: 1