Hello Guest it is July 22, 2019, 08:26:08 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - albertcnc

Pages: 1
1
General Mach Discussion / Re: Reinstalling
« on: March 19, 2009, 03:30:11 PM »
Vista version is the Basic home service pack  32 bit.

I am definitely choosing to install the port driver, the pulse engine is not in device manager.
When I use the add hardware control panel it appears to locate the driver file to install in a file called "Mach X Pulsing Engines". After you click NEXT a screen appears in which the sole entry is Mach 3 driver.   I select that , enter NEXT and the Hardware to install: Mach3 driver appears. When you click NEXT  a very brief screen appears which I cannot catch visually and then the next screen says The following hardware not installed: Mach3 Driver
An error occurred during installation of this device. The system cannot find the file specified.

Upon checking the device manager control panel there is no driver/pulsing engine in any of the file folders.

This is from the third download.  In retrospect the initial download and memory override reg  appears to have worked flawlessly. 

The big mystery to me is why a second attempt is seeming to be impossible.

2
General Mach Discussion / Re: Reinstalling
« on: March 17, 2009, 01:53:03 PM »
I am starting from scratch to learn cnc for a retirement hobby.  So I am building and now testing the first controller on  Dell Inspiron 530 I plan to dedicate to the project.  Anyway I was having trouble getting any response out of the computer so decided to start over with the demo software by uninstalling with the "uninstall Mach" and delete the Mach driver manually.

Now even after downloading the demo again or reusing the original download the Mach3 driver does not reappear and driver test says it cannot sense it.

Besides being stuck in my project I am wondering what would happen if I went ahead and purchased the software?

Thanks

Pages: 1