Hello Guest it is March 28, 2024, 05:22:45 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ktow

Pages: 1
1
General Mach Discussion / Re: Rhino ST/5 or ST/6 Lathe and MACH3
« on: March 26, 2012, 03:19:49 PM »
Sorry Chuck. I'm no help here. I sold ours out to a local gentleman since our school has a couple cnc machines in good order. Alas, too many irons in the fire to mess with another project. I wish you luck.  Ktow

2
General Mach Discussion / Re: Rhino ST/5 or ST/6 Lathe and MACH3
« on: March 10, 2009, 10:30:54 PM »
Orin,

Any luck with that ST/5?  I have one at the high school I teach at and have had it with Rhino's software.  After repeated conversations I'd really like a "modern" solution rather than using a dos program.

I now have the ST/5 with a 25-9 pin adaptor and Mach 3 loaded..... I'd love to hear a success story- I could use a little hope in my quest.

Let me know if you've had any luck!  Maybe we can stumble through this together!

Thanks,

Kevin-

High School Industrial Tech teacher

Pages: 1