Hello Guest it is March 29, 2024, 03:27:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sully3535

Pages: 1 2 »
1
General Mach Discussion / Re: Z axis stopped working
« on: February 20, 2018, 04:49:22 PM »
Switched to standard PC and seems to be working ok now.

2
General Mach Discussion / Re: Z axis stopped working
« on: February 20, 2018, 05:33:26 AM »
One circuit board. Now none of them work. x y z. >:(

3
General Mach Discussion / Re: Z axis stopped working
« on: February 19, 2018, 07:07:13 PM »
 Z DRO still working?  Yes

Does your BoB have LEDs on the outputs and if they do are they working? Yes and yes

Could you swap the driver for say the X axis driver to see if the fault follows the driver? How do I do this?

4
General Mach Discussion / Re: Z axis stopped working
« on: February 19, 2018, 04:17:07 PM »
Please see attached. The input signals current state number drops and then fluctuates. That's when it stops working.

5
General Mach Discussion / Z axis stopped working
« on: February 19, 2018, 06:48:01 AM »
Everything was working fine through several runs and then the z axis stopped working properly. x and y still work fine. I just replaced the power supply and this fixed it before. On the ports and pins page z axis is checked. Am I missing something?

6
General Mach Discussion / Re: MAch 3 stops working
« on: February 16, 2018, 01:44:52 PM »
It was the power supply. Got a new one, installed it, a few tweaks to Mach3 and it works great.

7
General Mach Discussion / Re: MAch 3 stops working
« on: February 13, 2018, 07:06:10 AM »
Is it possible the problem is with my power supply? I believe that just went out on me.

8
General Mach Discussion / Re: MAch 3 stops working
« on: February 13, 2018, 05:00:52 AM »
No new programs.

9
General Mach Discussion / Re: MAch 3 stops working
« on: February 12, 2018, 05:00:42 PM »
Must be 32 then. It has worked for years.

10
General Mach Discussion / Re: MAch 3 stops working
« on: February 12, 2018, 03:03:52 PM »
Windows XP
64 Bit
Pulse frequency drops from 29000 to 1000 and is erratic after that. When the pulse frequency drops the motors stop working.

Pages: 1 2 »