1
General Mach Discussion / Re: Geckos Faulting
« on: March 03, 2009, 11:08:44 AM »
we are running geckodrive servo 6320 on a plasma cutter. I don't think we have ever run 6 continuous yet, but as for overheating not sure how to check that other than put my hand on them and none have ever been hot. the problem has mostly been with the "y" axis. We will be running through a pattern then in the exact same spot every time the gecko will fault. It doesn't stop it just re-zoroes at that point and continues cutting the part.
Thanks for the info
Thanks for the info