1
General Mach Discussion / Re: X axis will not change direction during cut
« on: March 01, 2009, 05:08:48 PM »
Yes all wiring is 22 gauge and shielded.
Are you talking about the 3x 4" IDC Cable 10-pin from the BOB to the individual drivers as possably being bad and causing the noise?
Forgive me but what do you mean by Active State?
I did find this in the driver paperwork "The SideStep is negative logic. The STEP, DIRECTION and ENABLES lines should be inverted in your software", I don't really know what that means but I thought I would mention it.
Are you talking about the 3x 4" IDC Cable 10-pin from the BOB to the individual drivers as possably being bad and causing the noise?
Forgive me but what do you mean by Active State?
I did find this in the driver paperwork "The SideStep is negative logic. The STEP, DIRECTION and ENABLES lines should be inverted in your software", I don't really know what that means but I thought I would mention it.