3
« on: February 27, 2009, 12:36:00 PM »
I have become real interested in trying the Mach 3 after reading for the last week or so. I had previously had the Camsoft installed (Don't like it at all after dealing with them for over many months). I had the Galil motion control installed, and then had a problem with a bad connection on a hot wire in the mill I aquired and shorted to ground. Completely fried out the Galil and the PC. I am now ready to get it running again. I'll have to post a picture in the future of what not to do to your hardware.
Is the Galil driver set able to work with the legacy cards like the DMC-1040 or do I need to have a newer card? Is there a list of the Galil that has been tested or designed to run with the Mach drivers?
Thanks