1
General Mach Discussion / Re: Mach3 on 64 bit Windows XP? "No Driver sensed installed. Run Driver Test"
« on: February 21, 2009, 05:13:14 PM »
Dear Hood,
I have tried all. Enabled the 2-7 pins in ports and pins. Also changed them to active low (on and off). Did the driver test. Came back excellent. And several other things.
If I uninstall and reinstall, I know I would have to begin again but it that the right thing to do at this point?
Dan326
I have tried all. Enabled the 2-7 pins in ports and pins. Also changed them to active low (on and off). Did the driver test. Came back excellent. And several other things.
If I uninstall and reinstall, I know I would have to begin again but it that the right thing to do at this point?
Dan326