1
General Mach Discussion / Re: edge finding/2.5D probing
« on: February 09, 2009, 05:55:01 AM »
Hi,
I was wondering if someone could help.
I've installed the software but when I run the Gcode to do the edge finding I get the error:
cannot do G1 with zero feed rate on line #6
Does anyone know what I am doing wrong?
TIA
I was wondering if someone could help.
I've installed the software but when I run the Gcode to do the edge finding I get the error:
cannot do G1 with zero feed rate on line #6
Does anyone know what I am doing wrong?
TIA