1
General Mach Discussion / Re: Mach3 and a tube bender
« on: February 18, 2009, 07:06:01 PM »
Ha! Thanks for all of your help.
I just started having some really weird issues. My Retract (M4) (output3) is back to turning on really quickly, then turning off. The LED on the relay board goes bright for less than one second, then flashes very dimly. I read 0VDC on the incoming 5V signal. I don't have a problem at all with M3 (output 2). Very weird... any ideas?
I had a typo a few posts up when I mentioned the ActivateSignal(OutputX) function. I did type it the correct way in the macro.
I just started having some really weird issues. My Retract (M4) (output3) is back to turning on really quickly, then turning off. The LED on the relay board goes bright for less than one second, then flashes very dimly. I read 0VDC on the incoming 5V signal. I don't have a problem at all with M3 (output 2). Very weird... any ideas?
I had a typo a few posts up when I mentioned the ActivateSignal(OutputX) function. I did type it the correct way in the macro.