1
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: February 03, 2009, 05:28:36 AM »
Hey Guys
I am very new to this- I am planning to set up a plasma cutter table using Mach3
So far I have been just trying to figure out a few problems with it translating G code that is generated from CamBam.... On one computer, it tranlates perfectly but on the computer I am going to use for the machine it won't translate- the error saying "radius at end of arc differs to radius at start" appears.
Have any of you guys encountered this before and if so, what's the fix???
Cheers Rob
I am very new to this- I am planning to set up a plasma cutter table using Mach3
So far I have been just trying to figure out a few problems with it translating G code that is generated from CamBam.... On one computer, it tranlates perfectly but on the computer I am going to use for the machine it won't translate- the error saying "radius at end of arc differs to radius at start" appears.
Have any of you guys encountered this before and if so, what's the fix???
Cheers Rob