Hello Guest it is March 29, 2024, 01:39:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - alexjoelle

Pages: 1
1
LazyTurn / Re: LazyTurn cuts where I don't want it to cut
« on: June 23, 2011, 07:57:07 PM »
awander,
1-Save your Gcodes and Mcodes and load the codes in Mach3Turn.
2-In the cycle menu, move down the codes lines and you will see the toolpath.
3- When you reach the part of the codes you do not want take the line numbers (exemple between 300 and 3000).
4- Edit your codes and delete the lines, resave the Gcodes.
5- Retry it in Mach3Turn simulation to see if you remove the lines you do not need

2
LazyTurn / Re: LazyTurn cuts where I don't want it to cut
« on: June 23, 2011, 07:46:01 PM »
Try grabbing the yellow arrow and draggin it to the left to indicate a different start location..

Art


Pages: 1