Messages

1

General Mach Discussion / Re: Installation Problem - Driver Test will not run

« on: January 27, 2009, 05:44:38 AM »

Tried both drivers. No luck. I can't figure out what would the drivertest program from running at all.

Bruce Buchner

2

General Mach Discussion / Re: Installation Problem - Driver Test will not run

« on: January 27, 2009, 04:28:26 AM »

Uninstalled and reinstalled everything twice. PP driver box checked on install and MachX driver shows up under system hardware. When you double click on Driver Test nothing happens. It just will not run.

Bruce Buchner

3

General Mach Discussion / Installation Problem - Driver Test will not run

« on: January 26, 2009, 09:27:19 PM »

Have had Mach 3 loaded and running for several years. Mother board died so as long as I am setting up new computer decided to load latest lockdown version. New computer is a P4 2.8 ghz with a new hard drive and a new install of windows XP Pro. Installed Mach3 but DriverTest will not run and when I start the program the motor tuning screen will not run either. Parallel port # is correct and it is configured as EPP+ECP. Driver shows up in system Hardware. Rebooted several times. I assuming I have done something stupid. It has been several years since I last installed it and since it worked for what I needed I didn't change it.

Any ideas?

TIA
Bruce Buchner