Messages

1

General Mach Discussion / Re: Any interest in a plugin to run a GS2/GS3 VFD (Automation Direct).

« on: May 12, 2013, 12:23:23 AM »

I use the GS2-11P0  and an HSD spindle.  I am  interested in your work.  Also use Gerry's screen set. Nice work Gerry.

Thanks

2

Show"N"Tell ( What you have made with your CNC machine.) / Re: Isolation Routing PCB's and Local System Rotate.

« on: December 09, 2012, 11:35:08 PM »

I am also lucky as mine is mounted in a solid brass tube. The cable exits the tube and appears CA or something similar was used to secure the cable from twisting.

Very interesting thread. Thanks to Tweakie for his usual good job.

Jack

3

Show"N"Tell ( What you have made with your CNC machine.) / Re: Isolation Routing PCB's and Local System Rotate.

« on: November 25, 2012, 11:02:19 PM »

Is there a link for the one you bought?

4

General Mach Discussion / Re: uln2003 controller

« on: June 22, 2012, 11:46:08 AM »

I use Kaspersky and it went into protection mode and it was unhappy with that link as well.

I would proceed with caution if your system doesn't have some sort of protection.

JD

5

General Mach Discussion / Re: Importance of Non-Intgrated Vodeo Card

« on: June 17, 2012, 11:41:00 PM »

I was given one that was low profile but it still was too long to fit in the available bus.

6

General Mach Discussion / Re: Importance of Non-Intgrated Vodeo Card

« on: June 17, 2012, 05:22:55 PM »

I am using the Dell GX280 too (actually I am using two. One for Vcarve and one to control a Camaster Stinger)  and do not have any issues I am aware from the viewpoint of a 'newby'. Let me know what video card you wind up using and I may do the same just for fun.

Thanks, JD

7

General Mach Discussion / Re: USB MACH3 Pendant

« on: November 13, 2011, 12:36:59 PM »

I ordered one of those along with several others from Joe's Hybrid website. I suppose 5 is a small sampling but the failure rate was about 50%. Mine had a defective '+X' button and the lights lit up one time.  Mine will be on the way back to HKG tomorrow.

Ody