1
General Mach Discussion / Re: CHALLENGE - PRESENTED FOR DISCUSION
« on: July 29, 2009, 05:16:28 PM »
I started in deskcnc in dos version for what it cost for lazycam & Mach3 this is a good software for the hobbies,
yes they to have there bugs. But if dry run or Air cut the show up ,then you can edit them out. If you are
a production shop or you make a living at this this software is not for you!!!
Dan
yes they to have there bugs. But if dry run or Air cut the show up ,then you can edit them out. If you are
a production shop or you make a living at this this software is not for you!!!
Dan