Hello Guest it is March 28, 2024, 08:47:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - p38nut

Pages: 1 2 »
1
General Mach Discussion / Re: Rotary axis
« on: April 20, 2012, 08:52:54 AM »
That worked.  Also found in the motor cable I had used blue wire on one end and green wire on other end.  Works wonders now that both phases are connected.  Guess my vision on colors need tuning.  Thanks.  Mike

2
General Mach Discussion / Re: Rotary axis
« on: April 19, 2012, 03:29:41 PM »
I will try that later on tonight.  Thanks you for your quick response.  4th axis(A) is sure a new learning curve.  Thanks again.  Mike

3
General Mach Discussion / Rotary axis
« on: April 19, 2012, 12:51:44 PM »
What are the keyboard keys for A+ and A-?  Scan codes appear to be 45,46.  Thanks.  Mike

4
Could I have the .tap files also?  Thanks.  Mike

5
I would sure appreciate the .tap files.  Nice job on the engine.  Thanks.  Mike

6
General Mach Discussion / Re: Work offsets not being saved
« on: July 02, 2007, 11:08:46 AM »
Problem was that box was checked was "copy g54 from g59.253 on startup".  Unchecked that and things were fine.  Thanks to all.  Mike

7
General Mach Discussion / Re: Work offsets not being saved
« on: June 29, 2007, 07:49:06 AM »
I tried all the suggestions, nothing worked.  I looked through the files, particullarly mach3mill.xml but could not file the entries that should be modified.  What file(s) are modified for tools and work offsets?  Thanks.  Mike

8
General Mach Discussion / Re: Work offsets not being saved
« on: June 28, 2007, 02:06:30 PM »
Did you try changing the settings under the general configs?

Thanks
Brian


I'll try that this evening.  Thanks.  Mike

9
General Mach Discussion / Work offsets not being saved
« on: June 28, 2007, 10:11:59 AM »
My work offsets are not being saved even though MACH3  version .080 says they are being saved.  Am I not holding my mouth right or is there a secret to this?  Thanks.  Mike

10
LazyCam (Beta) / Re: G-Code line limitation???
« on: June 22, 2007, 01:43:57 PM »
I know of the 500 line g-code limit in Mach but this is in g-code generation from LazyCam.  I am only getting 50 lines out of LazyCam.  Thanks.  Mike :o

Pages: 1 2 »