1
General Mach Discussion / Re: Tangential control bit - buggy behavior?
« on: January 22, 2009, 11:38:01 PM »
I just went back to a legacy copy of Mach 3; no more issues with it cancelling my feedrates wen doing circular pockets. It's worth a try.
Also, the shuttering seems like an independent issue. Could be motor tuning or speed of feedrate vs cutting rpm?
Changed the dir and step values as high as possible in motor tuning as per someone elses post because large arcs (9' radius etc.) sounded like a dying cow. Movement is a little smoother but I am still missing steps occasionally. Maybe a higher kernal speed above 25mghz if my CPU will handle it?
Good Luck
T
Also, the shuttering seems like an independent issue. Could be motor tuning or speed of feedrate vs cutting rpm?
Changed the dir and step values as high as possible in motor tuning as per someone elses post because large arcs (9' radius etc.) sounded like a dying cow. Movement is a little smoother but I am still missing steps occasionally. Maybe a higher kernal speed above 25mghz if my CPU will handle it?
Good Luck
T