Messages

1

General Mach Discussion / Re: Compatability Question

« on: January 16, 2009, 11:55:44 AM »

Yes there are only 2 big wires. The motors are Pittman #13204C187 19.1 VDC. Attached is a photo of the lathe. It is a small one. Only 17" or so between centers.

2

General Mach Discussion / Re: Compatability Question

« on: January 16, 2009, 10:57:45 AM »

This is the X axis motor. bad photo.

3

General Mach Discussion / Re: Compatability Question

« on: January 16, 2009, 10:32:57 AM »

You are talking about the axis motors right?

4

General Mach Discussion / Re: Compatability Question

« on: January 16, 2009, 10:00:25 AM »

Pitman 19.1 VDC

5

General Mach Discussion / Re: Compatability Question

« on: January 16, 2009, 08:53:01 AM »

Sounds like my retrofit for my retrofit will cost more than I have in the whole lathe. Crap.

6

General Mach Discussion / Re: Compatability Question

« on: January 15, 2009, 04:29:58 PM »

Reference the attached print.

1. Servo Products Machine Interface D-3634-A

2. Servo Products Resolver Interface Analog Section D-3642-C

3. Servo Products Resolver Interface Digital Section D-3646-C

4. Servo Products 4 Channel DAC D-3658-C

5. Servo Products Front Panel Interface D-3817-B

6. Servo Products MAX CPU D-5454

7

General Mach Discussion / Re: Compatability Question

« on: January 15, 2009, 11:51:18 AM »

Found this print. Couldn't see any nameplate on the drives. I'll look again.

8

General Mach Discussion / Re: Compatability Question

« on: January 15, 2009, 09:11:53 AM »

See if this helps. I have no idea what I'm looking at.

9

General Mach Discussion / Re: Compatability Question

« on: January 14, 2009, 09:04:40 PM »

Not sure what to look for.

10

General Mach Discussion / Re: Compatability Question

« on: January 14, 2009, 04:41:57 PM »

i've got the operating and programming manual and a pile of wiring schematics. what kind of info are you looking for.