1
General Mach Discussion / Re: Advice sought on a version upgrade of Mach3
« on: February 28, 2010, 12:12:59 PM »
ah thanks, that's helpful. I take it that I should install the new software in c:\Mach3 (I had put it in a folder in Progam Files) and just copy in the xml files from the old to the new.
I'm concerned that I could overwrite or lose the configuration information. The previous owner had set up the servos etc. and I would not like to lose his settings if possible. I haven't been able to find where that is kept.
Any help is most appreciated.
I'm concerned that I could overwrite or lose the configuration information. The previous owner had set up the servos etc. and I would not like to lose his settings if possible. I haven't been able to find where that is kept.
Any help is most appreciated.