Messages

1

General Mach Discussion / Re: Code hangs and z drils to China

« on: December 21, 2008, 08:22:42 PM »

We used the xml files off the dyna setup disc. Sorry, but were a little confused and new to this. Are these settings in mach or sheetcam? Is g4 set in sheetcam or mach 3? Thanks for the help.

2

General Mach Discussion / Re: Code hangs and z drils to China

« on: December 21, 2008, 12:55:28 PM »

Came with the equipment and has a license file so I am pretty positive it is a fully licensed version.  It does say it is a licensed version in the help about tab.

3

General Mach Discussion / Re: Code hangs and z drils to China

« on: December 21, 2008, 12:08:25 PM »

We are not getting an error code. It just stops at line 4910.

4

General Mach Discussion / Re: Code hangs and z drills to China

« on: December 21, 2008, 11:30:02 AM »

Version D1.90.026, it hangs when we run through the code on the computer, we have not put it to machine yet as we haven't gotten that far on our project, we are concerned with the z axis that just keeps going that it could damage plasma head, so trying to get it working correctly before we make first run to metal.  If we run in program run the code will hang at line 4910.   If we put it in toolpath and simulate program run the code it runs all the way through, if we use cycle start it hangs at line 110 and z just keeps going down.

5

General Mach Discussion / Re: Code hangs and z drills to China

« on: December 21, 2008, 10:18:23 AM »

Here is our test run it hangs on us at line 4910.

6

General Mach Discussion / Code hangs and z drils to China

« on: December 20, 2008, 11:16:17 PM »

We are new to CNC, using a Dyna 4000 Plasma, and are trying our first test run using the default Plasma Tap in sheetcam.  But when we load up mach 3 it will hang at carious lines whenever it start to do anything but linear lines.  We can upload or post the code if needed and tell you what line we hang at. Would really appreciate any help and or direction that we can be pointed.