Hello Guest it is March 28, 2024, 05:38:52 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - plasmaman

Pages: 1
1
General Mach Discussion / clarification needed
« on: October 29, 2008, 07:59:46 PM »
Hello,

I have spent several days trying to figure out how to use Mach3 in my plasma setup. I want to use 3 phase motors for x and y axis as well as for torch height.
I learnt that I could use one PWM output with MACH3 to drive one 3 phase motor by means of VFD. But... could I drive three 3 phase motors by means of three VFD's? Or at least two? :-)

Any help is highly appreciated, as I am in doubt should I pursue this kind of solution.

2
Hi,

I work at University. I want to organize a course about CNC and would like to use MACH3 for it. I have an issue though, but will post about it some other place.

Cheers

Pages: 1