Hello Guest it is April 19, 2024, 03:23:00 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - chip0411

Pages: 1
1
General Mach Discussion / Re: MAXNC CL10 "qaudrature" and MACH3
« on: December 11, 2014, 09:31:04 PM »
I don't remember when I bought my Maxnc, but is was sometime between 1998-2005.

Thanks

2
General Mach Discussion / Re: MAXNC CL10 "qaudrature" and MACH3
« on: December 11, 2014, 09:06:15 PM »
I am new to MACH3 and am trying to setup my Maxnc10 CL. Every time I turn on the mill, the spindle turns on. What am I doing wrong? Can someone post screenshots of their settings? I should note that I can jog the X, Y, and Z axis fine.

Thanks for your help!

Pages: 1