Hello Guest it is March 29, 2024, 04:16:06 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jliggett

Pages: 1
1
General Mach Discussion / Re: Help Please
« on: October 20, 2008, 04:37:11 PM »
Here is the G-code

2
General Mach Discussion / Re: Help Please
« on: October 20, 2008, 04:32:49 PM »
Here are some pics and files. Thanks!

3
General Mach Discussion / Re: Help Please
« on: October 20, 2008, 03:57:58 PM »
Bought the DXF tool a while ago, still cuts bad, Constant Velocity has been on, I really am getting to my wits end.  I would like to post a cut file, along with the G-Code, and some pics of the edges I'm getting, but how do I post a file? I click on insert image, but it just inserts this ---->. Can't find how to post an attatchment.

4
General Mach Discussion / Help Please
« on: October 20, 2008, 01:52:29 PM »
I am using Corel X3, exporting as an .EPS, then using Cut 2D to generate G-Code out to Mach 3 running a Vortech router. in Corel, and Cut 2D, the files look clean, with minimal nodes.
However, when I run the machine, it cuts like crap, going around curves, (and sometimes straight lines), with a jerky motion, like it's starting and stopping hundreds of times. The number of lines in the G-Code is in the thousands for a relatively small part. I am sure that it is generating way too many lines. Does any body have an idea of how I can reduce the number of segments in the code to get a smooth cut? As soon as I can, I will post some pics and cut file for somebody to look at to hopefully help me from pulling anymore hair out(Tribal is not helping much) Any thing else I need to add, please let me know.  Thanks, Jon from Austin

Pages: 1