Hello Guest it is March 28, 2024, 09:50:27 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dwayneinfo

Pages: 1
1
Seems to me that you could just jog it very close then insert the plate. Set the feedrate slow and touch off on alluminum, it should be soft enough to not hurt the tooling. Does this sound right to the people who know?

Dwayne

2
Scot where do I set the thicness of the plate at in the script? Also the set position once raised along with the feed speed to plate?

Dwayne

3
Scott and Brian,

Thnks for replying. I will try to get something hooked up in the next few days. Tired of trying to look and see if I am on the part/table or not. My eyes are too old to let me see if the thing is right or not. Not to mention this has got to be faster and way moe accurate.

Dwayne

4
Which input? The one in Mach for probe?

5
Happy New Year everyone, I am new to this and have built a router. I am actually using it now to build the second router. I MUST have more speed, cutting area and accuracy.  ;D I have been reading some this morning and want to set up the Auto Tool Zero button. I found a few post about the scripting needed and I think I understand how to use and set to the button. What I really need to know is how do you physically connect a touch plate? I want to set a plate with a known thickness under my router. Hit the button and have it lower to the plate. Zero the DRO and then raise an inch or so. Any help would be appreciated.

Dwayne


Pages: 1