Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Don C

Pages: 1 2 3 »
1
General Mach Discussion / Re: Tangential cutter
« on: August 18, 2015, 07:58:25 PM »
Ok, got it figured out, I think. You have to have your z lift equal to the depth of cut and the distance above your work that you want your head to prep.
Thanks
Donald Clifton

2
General Mach Discussion / Re: Tangential cutter
« on: August 18, 2015, 09:26:35 AM »
Is Mach4 going to have a tangential function. Mach3 was such a great program and yes the tangential part kind of came and now gone. Thanks for the help I'm going Bach thru the different versions now.
Thanks
Donald Clifton

3
General Mach Discussion / Tangential cutter
« on: August 17, 2015, 02:33:34 PM »
The newest version of mach3 doesn't lift before prepping the head. It lifts and prepped at the same time. This was fixed in a earlier version but is back not working.
Thanks
Don Clifton

4
General Mach Discussion / Pinout for a ascension controller
« on: July 26, 2014, 12:50:05 PM »
I'm looking for the pinout for a Ascension 1000 controller. This one has 5 gecko 202 drives. Any help would be great fully appreciated.
Thanks
Don Clifton

5
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: June 09, 2014, 02:33:04 PM »
Thanks Ger21

6
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: June 09, 2014, 01:54:21 PM »
were can I download Darwin (parallel port plugin).
 Thanks
    Don Clifton

7
General Mach Discussion / Re: radius to end of arc differs from start
« on: June 19, 2013, 09:21:33 PM »
Ger, what is the differents between a g91 and g91.1. In the mach3 arc pp in aspire it writes a g90 and a g91.1.
Thanks don Clifton

8
General Mach Discussion / Re: Mach3 running a Shark Pro Plus
« on: July 01, 2011, 03:39:01 PM »
Thanks for the reply. The controller my friend has is the ncpod with gecko 250's. The gecko 250 are mounted to the ncpod board. We are going to replace the ncpod with a gecko 540. Looks like the shark has little or no support which is a shame.
 Thanks again for the help
    Donald Clifton

9
General Mach Discussion / Re: Mach3 running a Shark Pro Plus
« on: June 26, 2011, 08:46:14 AM »
Didn't find anything of interest on their forum. was hoping that someone here could help.
 Don Clifton

10
General Mach Discussion / Mach3 running a Shark Pro Plus
« on: June 25, 2011, 06:25:26 PM »
I'm trying to get a Shark pro plus running on Mach3 for a friend but haven't had any luck. I have download and installed the firmware update and the ncpod plugin but Mach does nothing. DRO don't even move. Is there a XML file or something else I'm missing.
Thanks
Don Clifton


Pages: 1 2 3 »