Guest
Show Posts
1
General Mach Discussion / Re: G52 with Tool Radius Comp (G41)
« on: October 12, 2008, 03:20:10 PM »
Has this been fixed?
?
Same problem - the program reuses the first set of offsets which are set as absolute after the during the load offset pass.
This can be verified in the plot by looking at the white lines between the start of the second copy and the original first plot.
? Same problem - the program reuses the first set of offsets which are set as absolute after the during the load offset pass.
This can be verified in the plot by looking at the white lines between the start of the second copy and the original first plot.