Hello Guest it is April 11, 2021, 09:56:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bshaker1

Pages: 1
1
General Mach Discussion / Re: Need help
« on: January 11, 2007, 07:46:54 PM »
Yes I can It was a generic fanuc post from mastercam x

2
General Mach Discussion / Need help
« on: January 11, 2007, 06:41:50 PM »
All the part programs that I load into Mach 3 always come out to where the part is to small to see in the view window. The part is in a Shaded box with a yellow dashed border around it, the part is in the bottom left corner and I guess it's the machine cordinates in the upper right corner. If I were to run this on my machine the part would be way off the table(machines limits). What am I doing wrong.

3
General Mach Discussion / Re: download problems
« on: December 24, 2006, 11:27:33 PM »
Found my problem. Since the download affected 3 other computers it finally hit me that it might be my network. I unplunged my ISP cable from the network and pluged it directly into an independent computer and bingo.

4
General Mach Discussion / Re: download problems
« on: December 24, 2006, 07:36:55 PM »
I've tried on  3 other computers they all including the new say that the program has been saved but when I try to run another error comes up that microsoft has encoutered a problem and you know the rest

5
General Mach Discussion / Re: download problems
« on: December 24, 2006, 06:59:05 PM »
I've tried several times with no results. I just purshased a new computer to run my mill. I have a liscensed version on my destiop and trying to put it on my new computer, version 1.84.002 downloaded with no problem but now I'm stuck

6
General Mach Discussion / download problems
« on: December 24, 2006, 06:07:52 PM »
I saved mach3 ver2.0.009 update install onto my desktop, but when I go to install it keeps coming up with an error cannot decomprees setup program

Pages: 1