Hello Guest it is January 20, 2021, 08:05:08 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bjm323

Pages: 1 2 »
1
Are you still selling licenses for this? Has anyone tried this with an ethernet smoothstepper?

2
General Mach Discussion / Re: edge finding/2.5D probing
« on: December 27, 2012, 02:46:47 PM »
Hi Jeff - I've sent you a PM.

Hi Terry - I'm currently working on the DELUXE model which will have some NICE new features - preview coming soon! (I'm also the most part through coding a brand new all singing all dancing screen editor).

Cheers

Ian

Any progress on this Stirling?

3
Very cool Dave.  8)

4
SmoothStepper USB / Re: SS and spindle motor control
« on: August 18, 2009, 05:02:15 PM »
Yes it is.

5
SmoothStepper USB / Re: SS and spindle motor control
« on: August 18, 2009, 03:59:32 PM »
The spindle configuration in SS is checked on relay/none. I tried checking the PWM and it works when commanded but the RPMs are all over the place.

6
SmoothStepper USB / Re: SS and spindle motor control
« on: August 18, 2009, 05:05:26 AM »
Here is the Ports & Pins setup. I'll check the SS configuration when I get home from work. Thanks


7
SmoothStepper USB / Re: SS and spindle motor control
« on: August 18, 2009, 04:52:04 AM »
Hi Jeff. Yes, I can click the spindle button on the Mach screen and the motor will turn on/off but will not when the gcode calls it out. As for the SS configuration, I don't know what it is set at since someone else has installed and configured it for me. I can't remember the spindle settings in the Ports & Pins tab off hand but I will post that info today after I get home from work. Thanks

8
SmoothStepper USB / SS and spindle motor control
« on: August 17, 2009, 08:06:55 PM »
I'm having a bit of a problem. In parallel port mode my spindle motor comes on manually and when instructed to in the gcode. Now with the smoothstepper I can manually turn the spindle on but it won't work when instructed in the gcode. All settings in the pin and ports config are set the same. Am I missing a setting somewhere?  ???

9
General Mach Discussion / Re: manual tool change macro needed
« on: February 26, 2009, 04:50:37 PM »
I finally got this figured out using a second parallel port and another BOB since all the inputs were being used on the first one. The only problem now is with the blue screenset it does away with the spindle control and I need it also.   :(

10
General Mach Discussion / Re: manual tool change macro needed
« on: January 11, 2009, 04:16:38 PM »
Thanks for posting this Friedrich. Looks like I have some reading to do now. If I understood what I've read so far, you made the probe connections to the second parallel port that you added?

Pages: 1 2 »