Hello Guest it is March 28, 2024, 09:38:35 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - WillyB

Pages: 1
1
Hi Guys

What is required to change Mach 3 to work as the Coil Winder? What directory do you install the Screen File in? What else needs to be changed to make it work? I am interested in seeing how it works and possibly building a Coil Winding machine. Thanks for your help.

Willy

2
General Mach Discussion / Re: Hand Pendant MPG
« on: February 19, 2007, 05:03:33 PM »
Hi Terry & Peter

Anyone know what was used to make the Labels for this Pendent?  Looks nice.
Would like to do something similar for my Pendent.

Thanks.

Willy

3
Show"N"Tell ( Your Machines) / Re: Brian's Emco Compact 5 Retro
« on: July 10, 2006, 06:52:11 PM »
Hi Brian

Your new CNC Lathe looks to be in very good condition.  Where did you pick it up from?  I have noticed that allot of Schools have these types of Lathes.  I plan to follow your thread as I would someday like to either convert or purchase something similar.  Keep up the good work.  Take lots of pictures.  All the best

Regards
Bill

4
General Mach Discussion / Mach Spindle Load Meter.
« on: November 27, 2005, 08:23:05 PM »
Hi Guys

Just finished signing up and reading all the interesting posts.  Man, this CNC stuff is exciting. Can't get enough of it.

I do have a question on installing a Load Meter for the Spindle Motor and having it show up in Mach.  I am planning to use a 3 phase Motor and a VFD.  From what I have found so far, most of the VFD's do not have any type of output signal for the amount of currant the Motor is drawing?  I will also be using a Peter H. IOMod Board if this would help?  Has anyone installed a Spindle Load Meter?  Thanks for the help.

Regards
WillyB

Pages: 1